I will do my best to drive the car to the dealer with the lights on but when it comes on Im at work smh. The recall includes some Crosstreks, Forester, Impreza and WRX models as far back as 2008. Another perspective here, but keep in mind this happened to me previous to any modification work on my '09 WRX, so your situation may be related to the reflash as UK above me stated.
However, I ran into a problem yesterday while driving home in the snow. In hindsight I wish I would have played around and tried to adjust it before buying a new one. I did not need to use any tools to replace the old switch which was nice. And now after posting I realize this thread was brought back from 2020 for no reason at all by the poster before me, lol. Dont just start the car after a reflash, turn the ignition off, that way it clears the time out codes. Is there any way I can turn these lights off temporarily until I get the back door fixed? I also have a short video on Youtube but for months no one even looked at it. Hill Assist and ABS Lights ON. This is one of the main causes of the Hill Start Assist not being available. Chapter/Region: NESIC.
Edit: I should also add that my check engine light is not on. I took apart my bad switch after replacing it with the new one. Keep pressing the brake until you hear the sound for the system's activation. This post is for entertainment purposes only. The door light on the panel on my dash board and the lights on the roof top of the car stay on.
Users online have stated that this problem went away after they restarted their car. 5xt-r with FMIC and all supporting mods for E85. We were lucky that we checked to see if garage door was down before going to bed. Abs traction control and hill assist light on foot. However, I check this morning and it looks like I have the newer version of the switch which makes me worry it's something else. The first question - Is this only one-speed sensor or is these a sensory for all the wheels? Took it to the dealer and they can't find anything wrong, in all fairness the truck runs fine but I hate to look at those two lights ON.
Take it to the dealership. Below is some more info about the problem: What does Ford Hill Assist do? Traction, ABS, and downhill assist lights turning on. To make the Hill Assist system work, you simply get to a hill and use the brakes to stop your Ford on it completely. I need to drive the car to dealer with the symbol lights on so they can look them up. That's it for my post on this issue. Genuine Subaru 83311FJ001 Switch – Stop Lamp for Bulb, 1 Pack.
When you reflash you are supposed to turn the ignition off once it uplaods, wait a few seconds and turn it back on again to prevent this. Got the same issue twice, my problem was abs downhill, abs and traction went on; went to the dealer CHEVROLET AUTONATION twice charging me US 100 dollars each time, told me I have two sensors that failed just one week difference. Thanks for any advice on how to get my problem with this issue resolved. Google search has some info with others that heve experienced these issues but I am looking for some specific basic questions that I need some help with. I may try putting this one back in. I hope you find this useful if you have your Subaru ABS light, traction control and hill assist lights stuck and wondered what the cause might be. I HAVE A 2013 KIA SORRENTO AND JUST HAD THE ENGINE REPLACED. Abs traction control and hill assist light on 2007. Thank you, * Registered users of the site do not see these ads. If you don't have an OBD-II scanner, these issues should be your first guesses. How do I reset Hill Start Assist? This is a system that makes life easier in hilly areas. If your interested in saving money and on your next Oil change check out this post.
SOMEONE POSTED THAT THERE WAS A RECALL PER KIA BUT I CALLED AND THEY SAID NO RECALL. Just replaced the steering wheel with a damd flat bottom. Typical Repair Cost: - No data. This is for a 2010 STi. Abs, traction control light and hill assist lights wont go off after start up. When I got home I did a quick google search and found others that had this issue, and that it appeared to be an easy fix. Abs traction control and hill assist light on 2005. You should be able to get this at your local Subaru dealer as well. I had this happen repeatedly and found posts about faulty brake light switches causing those lights to illuminate with no CEL.
So far three times now after being tuned my ABS, traction control, and hill assist lights have came on at the same time. All advise and help is greatly welcomed! Location: MontebelloVehicle: 11 5door. 2017 Freightliner Cascadia DD15 and DT12 Automatic Transmission.