It was only recommended that the filters be cleaned after about 3 months. All these spares are available on the eSpares website. This page is, in part, a review that I did to answer some questions about the Dyson DC25. Poor Suction: There have been complaints that the DC25 has little or no suction. Please follow the appropriate routes to wash the filters and check for blockages. Dyson dc25 wand won't go back in order. Again, this is a washable filter. Repeat the steps until the water runs clear. That is somewhat of a problem but is easily solved. Press the release catch on the filter and pull filter out of the ball. Push the head onto the machine until it clicks into place.
When the handle is in place on the vacuum, the wand will slide down smoothly and easily into the hose. Open the Wand glamour cap and pull the Wand upwards. If for any reason this does not work please email - we are happy to help resolve this issue. If you are vacuuming something like pine needles, you may have a problem with them clogging the various sections of hose. If you're like me and already have plenty of rechargeable AA batteries, you won't have to invest in batteries and a charger. Dyson dc25 wand won't go back in case. It's also possible to suck something large up into the vacuum to make it lose suction. Press the button again to restart the brushes for vacuuming carpets.
Carry out the performance checks, and if your machine cuts out unplug and leave for at least 2 hours to cool down. If the Wand is jammed in the hose begin by removing the bin. There was a complaint that the hose was hard to extend. The hose plugs into the handle end of the wand. Bagless vacuums always have less capacity than bagged vacuums of the same style/size. This issue could be caused by a twisted hose. A pin is located on either side of the red peddle. Dyson dc25 wand won't go back in store. Close the end cover on the handle by sliding it.
Replace the wand into the bracket that holds it on to the Dyson body. Press the ON/OFF switch. Turn the wand around and put the hose on the bare end of the wand. It's very simple after you see it done once but not immediately obvious if you've never seen a vacuum like this. The second filter was also very dirty. How Do I Get the Wand Out of My Dyson? | eHow. This is why it's important to empty the canister as suggested by the manufacturer. Plug the machine in. Motor Exhaust Filter: When checking the motor filter (the one in the ball), tap it on a hard surface. Using the Hose: In one review I read about a DC25, someone complained that they had to use the 3ft wand and they couldn't understand why Dyson designed it that way. Check the Cleaner head entrance and machine inlet for any blockages and remove as necessary. To completely detach the bin from the cyclone - press the release catch at the top of the clear bin.
WARNING: Please do not use detergent, do not wash in a dishwasher or washing machine. This would cause it to stretch and the roller would not longer spin as it should (you could hear it slow significantly on various parts of the carpet). To remove filter B firstly recline the machine. You want the air to be flowing up through the carpet, not from around the perimeter of the head.
Dyson recommend you wash it once every 3 months. Do not allow any other part of the vacuum to get wet. When you open the vacuum and pull the bag off of the internal nozzle that goes into the bag, immediately cover the hole in the bag with a couple of strips of packing or duct tape. Just ring it under the tap and give it a good ring out and leave it to dry for 24 hours. Close the end cap and lock it using a coin. I have checked to make sure here are no blockages n the wand and hose, that the hose is not twisted, I have unclipped the hose and tried to fit it in without the wand and it still doesn't fit.