Do NOT attempt to disassemble the atomizer before submerging fully assembled into ISO. Do not get the base wet – it's electric – it will break. Here's what you should look out for. Drop the fully assembled atomizer into ISO for with a paper towel and set aside. High, mostly colored in green means that your battery is around 100 – 60 percent while medium or yellow means that you're running at 60 – 30 percent of battery while low or red means you're at 15 – 0 percent of battery power. Remove the glass bubbler. The different temperature settings are categorized or named as low, medium, high, and peak. To cycle through these temperature levels simply press the power button once. Puffco Peak 4 unique temperature profiles. The battery is represented in three levels. The Puffco Peak lets you check the battery level so you'd know when it's time to charge your device.
Apart from what the Puffco Peak tells you with its LED lights, here are some of a few things you should avoid when using the Puffco Peak. Do not overfill the glass bubbler. 3 Red Flashing Light – Low Battery Level. Allow the unit to cool down. Never store the Puffco Peak with water on the bubbler. Unfortunately for me I have purchased a new chamber(tested on friends Pro, it works) and used another one, so a total of 3, but unfortunately my Peak is still giving me the same error light. Avoid heating the atomizer 4 times in a row. Make sure to be careful looking after the LED lights to tell what's wrong with the Puffco Peak.
I am in contact with support still. Solid Red Light – Overheating. Leave it in the solution for 30 min to an hour and rinse it with warm water and soap, Dry with a paper towel and set aside. The high temperature level is at 550 degrees and reaches vaping temperature at 25 seconds and works best with large loads of wax concentrates. WARNING: *After cleaning, allow all parts to thoroughly dry before use. When connecting threaded components, apply enough force and stop when you feel resistance. When loading avoid wiping off the concentrates on the side of the bowl. Avoid storing the Puffco Peak on a moist and humid area. So my Peak Pro started flashing red/blue the other day and I did everything to remedy that and it continued to do it, after trying to file a claim with puffco the app gave me an option to do a firmware update and now when I try to turn it on it flashes red and white?? Puffco Peak is equipped with an LED light system that tells you the actual status of the Puffco Peak. Make sure that all the components are completely dry before attaching it to the Puffco Peak body. Fill it with water just above the air holes. Take the atomizer and soak onto the same solution you used when cleaning the glass bubbler. Remove and replace the glass bubbler carefully and do not apply too much force.
Handle extra care when handling your bubbler, First clean the carb cap and the glass piece by soaking it onto a solution of 91%isopropyl alcohol. Your Puffco Peak Vaporizer needs to be cleaned Daily for best performance: -. Be sure not to let any liquid make its way to the battery. Can't find anything about this. Do not overfill the bowl. The medium heat profile runs at 500 degrees and reaches peak temperature at 20 seconds and works well with medium sized loads of concentrates.
Multi-Colored LED Lights. This can cause liquid to trickle down to the battery and make its way to some of the sensitive internal circuitry which can cause permanent damage. Finally, the aptly named peak temperature setting heats up your concentrates at 600 degrees and has a 25 second heat up time and can vaporize XL loads of concentrates.
Lower temperature level is at 450 degrees heating up at 20 seconds and works well with small loads of concentrates. When in use and you want large cloud production, take several short draws instead of long drags. 5 Flashing Light – Short Circuit. During use, wait for a minute before using again.